D-Link DAP-1325 setup using the web address dlinkap.local is very simple and quick. The D-Link wifi extender setup makes sure to extend your router’s network to eliminate dead zones from your home or office. The extender picks up the wireless signals from your router and increases its throughput. That way, the extender creates an extended network to deliver an undisturbed yet seamless networking experience. 

To set up the Dlink wifi extender, you need to login to the web interface of your device. The dlinkap.local web address is the gateway address that takes you to the Dlink web interface. In this post, we will discuss how to proceed with the D-Link DAP-1325 setup without any hassle.

D’Link Wifi Extender DAP-1325 Setup (WPS Method)

The WPS method connects your Dlink extender to the router’s network without making you go through the setup wizard or instructions. Just make sure that your router sports the WPS button. Follow the steps below:

1. Keep your router and extender powered On and close to each other. 
2. Thereafter, press the WPS button on your Dlink wifi extender. 
3. Within 2 minutes, press the WPS button on your existing router. 
4. After that, wait for a few minutes while both the devices connect using the WPS method. 
5. Then, the D-Link extender will blink green, which means the device has been set up.

Once the D-Link DAP-1325 setup completes, unplug your extender and place it in a place where you experienced a dead zone previously. 

D’Link Wifi Extender DAP-1325 Setup (Web Interface)

Configuring a Dlink wifi extender with your router’s network is easy and simple. This section will walk you through the instructions to set up your device. Please follow the below steps:

1. Firstly, unbox your D-link wifi extender and make sure to keep its antennas in an upward direction.
2. Thereafter, plug your device into the power outlet and turn it On. 
3. Then, take a laptop or a smartphone to connect to the extender’s network.
4. After that, open an internet browser and type http://dlinkap.local in the web address. 
5. The browser redirects you to the D-Link extender login page.
6. Then, enter the username and password in the respective sections and click Login.
7. Once you login to the D-Link extender management page, start with the D’Link wifi extender DAP-1325 setup.
8. Follow the on-screen instructions and finalize the settings of your range extender.

Once you complete the D-Link DAP-1325 setup, install your device anywhere in your home. Then, the device will start extending your existing network. 

Bottom Line 

There are two methods through which you can set up your D-Link DAP-1325 wifi extender. However, we recommend you configure your extender using the web interface method. The web interface method allows you the flexibility to configure the wireless settings of your extender as per your requirement. 

This post was all about the D-Link DAP-1325 setup. We hope you liked this post. If you need any assistance or you can’t set up your Dlink wifi extender, please feel free to get in touch with our support team.